Akfix HP242 is an easily applied anaerobic low viscosity pipe sealant used in hydraulic & pneumatic fittings with diameters up to 50 mm and servomechanisms.
Does not shrink when fully cured.
Shows great resistance to high pressure, vibration, solvents, heat up to 150°C, moisture,and corrosion.
Easly applied to hydraulic & pneumatic fittings with diameters up to 50 mm and servomechanisms.
Clean male and female threads before assembly with an absorbent tissue paper to remove any cutting oil.
Apply the adhesive with a 360 turn to leading threads of the male and female fittings.
Use an absorbent tissue paper to wipe off excess jointing compound in the direction of the thread.
Assembly parts and hold on for 24 hours at 22-24°C to ensure full curing of jointing compound.
For disassembly, use hand tools to remove mating parts. When it is hard to dissemble at room temperature, apply local heat until reaching 150°C and disassemble while hot. Then, remove any residual cured adhesive mechanically and clean parts with a proper solvent, acetone.